I model up almost everything now, partly because it helps me determine what pieces I need to cut, but also so I can incorporate 3d printed things like the grey light bar standoffs in this picture.

I was able to set that length so the light illuminated the whole table and not just a strip down the middle.

This isn't nearly all of my clamps, but it's a lot of 'em!

Glued up

Oak pins run through the whole width to add strength and (hopefully) keep it from twisting too much.

I was too aggressive routing this edge and a big chunk tore out. Too far along... we'll make a v2 of this one.

Hangs from the ceiling with stainless cable and really makes the felt pop.